Fuel Injection Pump RE502378 DB4429-5566 for John Deere Engine 4045 Loader 310E 310G 310SE 310SG 315SE 315SG Excavator 230LCR 230LCRD

Fuel Injection Pump RE502378 DB4429-5566 for John Deere Engine 4045 Loader 310E 310G 310SE 310SG 315SE 315SG Excavator 230LCR 230LCRD

This fuel pump is engineered as a direct replacement for the John Deere Engine 4045 Loader 310E 310G 310SE 310SG 315SE 315SG Excavator 230LCR 230LCRD. Manufactured to meet or exceed OEM specifications, it delivers reliable performance in demanding conditions. Each unit is tested for fuel flow, pressure rating, and durability before leaving the factory to ensure consistent quality across every order.

Vehicle Compatibility

Replaces OEM Part Numbers

RE502378 • DB4429-5566 • DB44295566 • Deere • Engine • 4045DT056 • 4045DT058 • 4045TT050 • 4045TT056 • 4045TT080 • 4045TT081 • 4045TT088

Signs You Need a Replacement

If your equipment is showing any of these symptoms, the injection pump may be the cause:

• Engine cranks but won’t start — The pump may have lost prime or stopped delivering fuel. Check for fuel at the filter outlet before replacing the pump.
• Stalling under load — A weak pump can’t maintain pressure at high demand. The engine runs fine at idle but dies when you put it to work.
• Fuel pressure warning (if equipped) — Modern John Deere equipment monitors fuel rail pressure. A low-pressure warning often means the pump is failing.
• Loud whining from fuel system — A failing pump makes a high-pitched whine that gets louder as it warms up. Normal pump noise is a low hum.
• Air in fuel lines — If you see bubbles in the transparent fuel line or the primer bulb won’t stay firm, the pump may be drawing air through a worn seal.
• Excessive return flow — Too much fuel returning to the tank instead of reaching the injectors indicates internal pump wear.

Before You Replace the Pump

Before replacing the pump, check the fuel filter and fuel lines for restrictions. A blocked filter causes the same symptoms as a failing pump on John Deere equipment. When installing the new pump, fill it with clean fuel before connecting the lines — this reduces priming time and prevents dry-run damage. After installation, bleed the system fully and check for leaks at all connection points. Replace the fuel filter at the same time as the pump to protect the new unit from debris.

Frequently Asked Questions

Will this fit my John Deere 4045?
Yes. This part is designed to fit the John Deere 4045, 310E, 310G among other models listed in the compatibility table above. Verify your specific model and engine code before ordering to ensure the correct fit.

Can I cross-reference RE502378 with DB4429-5566?
Yes. Both RE502378 and DB4429-5566 are interchangeable OEM numbers for this part. They refer to the same component with the same specifications, just different part number revisions.

My vehicle is a 4429 model – is it covered?
The compatibility range for this part includes 4429-5566. The 4429 model year falls within this range, but verify the engine code and body type match. Mid-year production changes sometimes mean two vehicles from the same model year use different parts.

How long does a John Deere fuel pump typically last?
Fuel pump life varies by application, but on John Deere equipment you can generally expect 5,000 to 10,000 hours of operation. Running the tank dry, using contaminated fuel, or neglecting the fuel filter are the top causes of premature failure.

You May Also Need