Fuel Injector DJ5E-9F593-AA 0261500206 0261500403 for Ford 2.0T Mondeo MK4 MK5 Edge Taurus 2015-2018
This injector seal kit is engineered as a direct replacement for the Ford 2.0T Mondeo MK4 MK5 Edge Taurus 2015-2018. Manufactured to meet or exceed OEM specifications, it delivers reliable performance in demanding conditions. Each unit is tested for fuel flow, pressure rating, and durability before leaving the factory to ensure consistent quality across every order.
Vehicle Compatibility
| Application | Details |
|---|---|
| Ford 2.0T Vehicle | See product specifications |
| Ford Mondeo MK4 2015 | 2017 |
| Ford Mondeo MK5 2015 | 2017 |
| Ford Edge 2016 | See product specifications |
| Ford Taurus 2015 | 2018 |
Replaces OEM Part Numbers
DJ5E-9F593-AA • DJ5E9F593AA • 0261500206 • 0261500403 • Application • Vehicle • Mondeo • 2015-2017Ford • 2016Ford • Taurus • 2015-2018
Signs You Need a Replacement
If your equipment is showing any of these symptoms, the injector seal kit may be the cause:
- Fuel leak at injector base — Copper washers lose their crush seal over time. If you see dampness around the injector, the seals need replacement.
- Fuel in coolant or oil — A failed combustion seal allows fuel pressure to escape into adjacent passages. This is a serious issue that requires immediate attention.
- Loss of compression on one cylinder — When the copper sealing washer fails, combustion gases blow past the injector body instead of pushing the piston.
Installation Notes
Clean the injector bore thoroughly before installing new seals. Any carbon or debris left in the bore prevents the copper washer from seating properly, causing a compression leak. Use a wire brush or bore cleaning tool, then wipe with a lint-free cloth. Install the seals in the order specified in the kit — the heat shield goes on first, then the copper washer, then the O-rings. Torque the injector to the specified value and recheck after running the engine under load.
Frequently Asked Questions
Which Ford models does this part fit?
Refer to the Vehicle Compatibility table above for the full list of Ford models. Each listing includes the body type, engine, and production years. Match your vehicle’s engine code (stamped on the engine block) against the listed codes to confirm.
Can I cross-reference DJ5E-9F593-AA with DJ5E9F593AA?
Yes. Both DJ5E-9F593-AA and DJ5E9F593AA are interchangeable OEM numbers for this part. They refer to the same component with the same specifications, just different part number revisions.
My vehicle is a 2015 model – is it covered?
The compatibility range for this part includes 2015-2018. The 2015 model year falls within this range, but verify the engine code and body type match. Mid-year production changes sometimes mean two vehicles from the same model year use different parts.
Do I need to replace the seals when removing injectors?
Yes. The copper sealing washers are single-use – they crush to form the seal and cannot be reused. Rubber O-rings harden over time from heat and fuel exposure. Even if the old seals look fine, they won’t seal properly on reassembly.
Reviews
There are no reviews yet.