2 Pieces Secondary Air Injection Pump 176100S010 for Toyota Tundra Sequoia Venza Engine 5.7L 4.6L 4.7L

2 Pieces Secondary Air Injection Pump 176100S010 for Toyota Tundra Sequoia Venza Engine 5.7L 4.6L 4.7L

This fuel pump is engineered as a direct replacement for the Toyota Tundra Sequoia Venza Engine 5.7L 4.6L 4.7L. Manufactured to meet or exceed OEM specifications, it delivers reliable performance in demanding conditions. Each unit is tested for fuel flow, pressure rating, and durability before leaving the factory to ensure consistent quality across every order.

Vehicle Compatibility

Replaces OEM Part Numbers

176100S010 • 17610-0S010 • 17610-0P010 • Toyota • Engine • Application • Following • Models • 2007-2013 • Tundra • V82007-2013 • Sequoia

Signs You Need a Replacement

If your equipment is showing any of these symptoms, the injection pump may be the cause:

• Engine cranks but won’t start — The pump may have lost prime or stopped delivering fuel. Check for fuel at the filter outlet before replacing the pump.
• Stalling under load — A weak pump can’t maintain pressure at high demand. The engine runs fine at idle but dies when you put it to work.
• Fuel pressure warning (if equipped) — Modern equipment monitors fuel rail pressure. A low-pressure warning often means the pump is failing.
• Loud whining from fuel system — A failing pump makes a high-pitched whine that gets louder as it warms up. Normal pump noise is a low hum.
• Air in fuel lines — If you see bubbles in the transparent fuel line or the primer bulb won’t stay firm, the pump may be drawing air through a worn seal.
• Excessive return flow — Too much fuel returning to the tank instead of reaching the injectors indicates internal pump wear.

Before You Replace the Pump

Before replacing the pump, check the fuel filter and fuel lines for restrictions. A blocked filter causes the same symptoms as a failing pump on equipment. When installing the new pump, fill it with clean fuel before connecting the lines — this reduces priming time and prevents dry-run damage. After installation, bleed the system fully and check for leaks at all connection points. Replace the fuel filter at the same time as the pump to protect the new unit from debris.

Frequently Asked Questions

Which Toyota models does this part fit?
Refer to the Vehicle Compatibility table above for the full list of Toyota models. Each listing includes the body type, engine, and production years. Match your vehicle’s engine code (stamped on the engine block) against the listed codes to confirm.

Can I cross-reference 176100S010 with 17610-0S010?
Yes. Both 176100S010 and 17610-0S010 are interchangeable OEM numbers for this part. They refer to the same component with the same specifications, just different part number revisions.

My engine code is LX570 with a 5.7L displacement – is this the right part?
Yes. Engine code LX570 with 5.7L displacement is within the supported range for this part. The full list of compatible engine codes includes: LX570. Confirm your engine code on the data plate attached to the engine block.

This listing is for 2 pieces – do I need to buy a full set?
This listing includes 2 units. For best results, replace all injectors at the same time rather than one at a time. Mixing old and new units causes uneven fuel delivery and shortens the life of the new parts.

You May Also Need