3/8 Fuel Line & Return Gas Tank Sending Unit for Ford Lincoln Continental 1969-1979
This fuel line is engineered as a direct replacement for the Ford Lincoln Continental 1969-1979. Manufactured to meet or exceed OEM specifications, it delivers reliable performance in demanding conditions. Each unit is tested for fuel flow, pressure rating, and durability before leaving the factory to ensure consistent quality across every order.
Vehicle Compatibility
| Application | Details |
|---|---|
| Ford Lincoln Continental 1969 | 1979 Application: Fit for following models: 1969-1971 |
| Ford Custom 500 3.9L 240Cu. In. I6 GAS OHV Naturally Aspirated1972 | 1974 |
| Ford Custom 500 5.0L 302Cu. In. V8 GAS Naturally Aspirated1969 | 1974 |
| Ford Custom 500 5.0L 302Cu. In. V8 GAS OHV Naturally Aspirated1969 | 1974 |
| Ford Custom 500 5.8L 5753CC 351Cu. In. V8 GAS Naturally Aspirated1969 | 1977 |
| Ford Custom 500 5.8L 5753CC 351Cu. In. V8 GAS OHV Naturally Aspirated1969 | 1971 |
| Ford Custom 500 6.4L 390Cu. In. V8 GAS Naturally Aspirated1969 | 1971 |
| Ford Custom 500 6.4L 6391CC 390Cu. In. V8 GAS OHV Naturally Aspirated1971 | 1973 |
| Ford Custom 500 6.6L 400Cu. In. V8 GAS Naturally Aspirated1971 | 1977 |
| Ford Custom 500 6.6L 400Cu. In. V8 GAS OHV Naturally Aspirated1970 | See product specifications |
| Ford Custom 500 7.0L 428Cu. In. V8 GAS Naturally Aspirated1970 | 1973 |
| Ford Custom 500 7.0L 429Cu. In. V8 GAS Naturally Aspirated1970 | See product specifications |
Replaces OEM Part Numbers
1969-1979 • 1969-1971
Signs You Need a Replacement
If your equipment is showing any of these symptoms, the fuel pump may be the cause:
- Fuel smell or visible wet spots — A cracked or perished fuel line seeps fuel. Diesel fuel lines harden with age and develop hairline cracks near connection points.
- Air in the fuel system — Air enters through deteriorated hoses, causing hard starting and rough running. Check all connections and replace any line that feels spongy.
- Collapsed line under suction — A reinforced fuel line can collapse internally, restricting flow. The engine runs fine at idle but starves under load.
- Fuel leaking at connection points — Old clamps lose tension and the hose shrinks over time. Always use new clamps when installing fuel lines.
Installation Tips
When installing new fuel lines, cut the ends square with a sharp blade — angled cuts cause leaks at the connection points. Use new clamps at every connection; old clamps have lost their spring tension. After installation, pressurize the system with the primer pump and check every fitting for dampness. Run the engine and recheck after 10 minutes of operation, as fittings can loosen slightly under vibration.
Frequently Asked Questions
Which Ford models does this part fit?
Refer to the Vehicle Compatibility table above for the full list of Ford models. Each listing includes the body type, engine, and production years. Match your vehicle’s engine code (stamped on the engine block) against the listed codes to confirm.
Can I cross-reference 1969-1979 with 1969-1971?
Yes. Both 1969-1979 and 1969-1971 are interchangeable OEM numbers for this part. They refer to the same component with the same specifications, just different part number revisions.
My vehicle is a 1969 model – is it covered?
The compatibility range for this part includes 1969-1979. The 1969 model year falls within this range, but verify the engine code and body type match. Mid-year production changes sometimes mean two vehicles from the same model year use different parts.
What material are these fuel lines made from?
This fuel line kit uses materials rated for the specific fuel type and pressure of your application. Diesel lines need to handle higher pressure than gasoline lines. Always install the correct fuel-rated line and use new clamps at every connection point.
Reviews
There are no reviews yet.