Carburetor with Air Filter 595216 AUC14748 Briggs & Stratton Engine 401577 405577 407777 John Deere EZtrak Mower Z235 Z255 Z335

Carburetor with Air Filter 595216 AUC14748 Briggs & Stratton Engine 401577 405577 407777 John Deere EZtrak Mower Z235 Z255 Z335

This carburetor is manufactured to OEM specifications as a direct replacement part. Each unit undergoes quality testing for flow rate, pressure rating, and durability to ensure reliable field performance. Designed for professional mechanics and fleet operators who need parts that fit right the first time.

Vehicle Compatibility

Replaces OEM Part Numbers

595216 • AUC14748 • Briggs • Stratton • Engine • 401577-0135-B1 • 405577-0118-B1 • 407777-0290-G5 • Application • Following • Models • Deere

Signs You Need a Replacement

If your equipment is showing any of these symptoms, the carburetor may be the cause:

• Engine floods easily — The float valve isn’t seating properly, allowing fuel to overflow into the bore. The engine loads up with fuel and won’t start until it clears.
• Lean surging at cruise speed — A blocked main jet or partially clogged passage causes the engine to run lean under steady throttle. It surges as the mixture alternates between lean and rich.
• Black smoke and rich smell — Too much fuel relative to air. Check the choke mechanism, float level, and jet sizes if the carburetor has been modified.
• Fuel dripping from the carburetor — A worn needle and seat or stuck float allows fuel to overflow. This is a fire hazard and should be fixed immediately.
• Hard starting when cold — The choke circuit may be blocked or the enrichment valve stuck. Cold-start problems on a carbureted engine almost always trace back to the choke.
• Inconsistent idle speed — The idle mixture screws may need adjustment, or there’s a vacuum leak at the carburetor base gasket.

Rebuild Tips

Before installing the new carburetor, clean the manifold surface and check the gasket for any damage or vacuum leaks. Set the idle mixture screws to the baseline position (typically 1.5 turns out from fully seated) before starting. After starting, warm the engine to operating temperature, then fine-tune the mixture screws for the highest smooth idle. Adjust the idle speed screw last. If the engine backfires through the carburetor, check the valve adjustment and ignition timing.

Frequently Asked Questions

Which John Deere models does this part fit?
Refer to the Vehicle Compatibility table above for the full list of John Deere models. Each listing includes the body type, engine, and production years. Match your vehicle’s engine code (stamped on the engine block) against the listed codes to confirm.

Can I cross-reference 595216 with AUC14748?
Yes. Both 595216 and AUC14748 are interchangeable OEM numbers for this part. They refer to the same component with the same specifications, just different part number revisions.

My vehicle is a 1577 model – is it covered?
The compatibility range for this part includes 1577-0135. The 1577 model year falls within this range, but verify the engine code and body type match. Mid-year production changes sometimes mean two vehicles from the same model year use different parts.

Should I rebuild or replace the carburetor?
If the throttle shaft has lateral play or the carburetor body is warped, replacement is the better option. A rebuild kit handles gaskets, jets, and needles but can’t fix mechanical wear. For most applications, a new carburetor costs about the same as a professional rebuild when you factor in labor.

You May Also Need