White 4mm Set Kit Fuel Line Pipe Hose 89031118 for Webasto Eberspacher Heater
This fuel line is engineered as a direct replacement for the Webasto Eberspacher Heater. Manufactured to meet or exceed OEM specifications, it delivers reliable performance in demanding conditions. Each unit is tested for fuel flow, pressure rating, and durability before leaving the factory to ensure consistent quality across every order.
Vehicle Compatibility
| Application | Details |
|---|---|
| White 4mm Set Kit Fuel Line Pipe Hose 89031118 for Webasto Eberspacher Heater Part Number:89031118 Specification:Pipe Color:WhiteMaterial: Plastic & MetalLong Pipe Diameter: approx.0.4×0.2cm(0.16×0.08inch)(ODxID)Short Pipe Diameter: approx.0.5×0.2cm(0.20×0.08inch)(ODxID)Long Pipe Length: approx.370 | 375cm(145.67-147.64inch)Short Pipe Length: approx.90-95cm(35.43-37.40inch) Item included:2 x Fuel Pipe(1 Long,1 Short)10 x Pipe Clamps5 x Connectors Applications:For Webasto Eberspacher Heater |
Replaces OEM Part Numbers
89031118 • Specification • Color • WhiteMaterial • Plastic • MetalLong • Diameter • approx.0.4 • 0.2cm • 0.08inch • ODxID • Short
Signs You Need a Replacement
If your equipment is showing any of these symptoms, the fuel line may be the cause:
- Fuel smell or visible wet spots — A cracked or perished fuel line seeps fuel. Diesel fuel lines harden with age and develop hairline cracks near connection points.
- Air in the fuel system — Air enters through deteriorated hoses, causing hard starting and rough running. Check all connections and replace any line that feels spongy.
- Collapsed line under suction — A reinforced fuel line can collapse internally, restricting flow. The engine runs fine at idle but starves under load.
- Fuel leaking at connection points — Old clamps lose tension and the hose shrinks over time. Always use new clamps when installing fuel lines.
Installation Tips
When installing new fuel lines, cut the ends square with a sharp blade — angled cuts cause leaks at the connection points. Use new clamps at every connection; old clamps have lost their spring tension. After installation, pressurize the system with the primer pump and check every fitting for dampness. Run the engine and recheck after 10 minutes of operation, as fittings can loosen slightly under vibration.
Frequently Asked Questions
Can I cross-reference 89031118 with Specification?
Yes. Both 89031118 and Specification are interchangeable OEM numbers for this part. They refer to the same component with the same specifications, just different part number revisions.
What material are these fuel lines made from?
This fuel line kit uses materials rated for the specific fuel type and pressure of your application. Diesel lines need to handle higher pressure than gasoline lines. Always install the correct fuel-rated line and use new clamps at every connection point.
Reviews
There are no reviews yet.